We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
Standard Practice for Testing for Leaks Using the Halogen Leak Detector(Alkali-Ion Diode) (Withdrawn 2013)
STANDARD published on 1.12.2006
Designation standards: ASTM E427-95(2006)
Note: WITHDRAWN
Publication date standards: 1.12.2006
SKU: NS-46746
The number of pages: 7
Approximate weight : 21 g (0.05 lbs)
Country: American technical standard
Category: Technical standards ASTM
Keywords:
freon leak testing, halogen leak testing, heated anode halogen detection, leak testing, ICS Number Code 31.080.01 (Semi-conductor devices in general)
Significance and Use | ||||
Halogen leak testing can be used to indicate the presence, location and magnitude of leaks in a closed vessel. This test method is normally used for production examination. Its use with halogenated refrigerant gases has been declining because of concerns about the effect of these gases on the ozone layer. |
||||
1. Scope | ||||
1.1 This practice covers procedures for testing and locating the sources of gas leaking at the rate of 2.2 10 14 mol/s (5 1010 Std cm3/s). The test may be conducted on any device or component across which a pressure differential of halogen tracer gas may be created, and on which the effluent side of the area to be leak tested is accessible for probing with the halogen leak detector. 1.2 Five methods are described: 1.2.1 Method A - Direct probing with no significant halogen contamination in the atmosphere. 1.2.2 Method B - Direct probing with significant halogen contamination in the atmosphere. 1.2.3 Method C - Shroud test. 1.2.4 Method D - Air-curtain shroud test. 1.2.5 Method E Accumulation test. 1.3 The values stated in inch-pound units are to be regarded as the standard. The metric equivalents of inch-pound units may be approximate. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||
2. Referenced Documents | ||||
|
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
Latest update: 2024-05-03 (Number of items: 2 896 946)
© Copyright 2024 NORMSERVIS s.r.o.