ASTM E2834-12
ASTM E2859-11
ASTM E2864-13
ASTM E2865-12
ASTM E2909-13
ASTM E537-12
Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM E487-14
Standard Test Method for Constant-Temperature Stability of Chemical Materials
STANDARD published on 1.3.2014
The information about the standard:
Designation standards: ASTM E487-14
Note: WITHDRAWN
Publication date standards: 1.3.2014
SKU: NS-46957
The number of pages: 4
Approximate weight : 12 g (0.03 lbs)
Country: American technical standard
Category: Technical standards ASTM
The category - similar standards:
Annotation of standard text ASTM E487-14 :
Keywords:
constant temperature stability (CTS), differential scanning calorimetry (DSC), differential thermal analysis (DTA), hazard potential, reactions, thermal, thermal analysis, thermal hazard, thermal stability, ICS Number Code 07.030 (Physics. Chemistry)
Additional information
| Significance and Use | ||||||||||||
|
5.1 This test method is a useful adjunct to dynamic thermal tests that are performed under conditions in which the sample temperature is increased continuously at a programmed rate. Results obtained under dynamic test conditions present difficulties in determining the temperature at which an exotherm initiates because onset temperature is dependent on heating rate. The test method described in the present standard attempts to determine the onset temperature under isothermal conditions where the heating rate is zero. |
||||||||||||
| 1. Scope | ||||||||||||
|
1.1 This test method describes the assessment of constant-temperature stability (CTS) of chemical materials that undergo exothermic reactions. The techniques and apparatus described may be used on solids, liquids, or slurries of chemical substances. 1.2 When a series of materials is tested by this test method, the results permit ordering the materials relative to each other with respect to their thermal stability. 1.3 Limitations of Test: 1.3.1 This test method is limited to ambient temperatures and above. 1.3.2 This test method determines neither a safe storage temperature nor a safe processing temperature. 1.3.3 When this test method is used
to order the relative thermal stability of materials, the tests
must be run under the same confinement condition (see 8.3).
1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.5 This standard should be used to measure and describe the properties of materials, products, or assemblies in response to heat and flame under controlled laboratory conditions and should not be used to describe or appraise the fire hazard or fire risk of materials, products, or assemblies under actual fire conditions. However, results of this test may be used as elements of a fire risk assessment which takes into account all of the factors which are pertinent to an assessment of the fire hazard of a particular end use. 1.6 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of whoever uses this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||
| 2. Referenced Documents | ||||||||||||
|
Similar standards:
Historical
1.4.2012
Historical
1.12.2011
Historical
1.9.2013
Historical
1.1.2012
Historical
1.2.2013
Historical
1.12.2012
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
