We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
Standard Practice for Characterizing Acoustic Emission Instrumentation
STANDARD published on 1.5.2004
Designation standards: ASTM E750-04
Note: WITHDRAWN
Publication date standards: 1.5.2004
SKU: NS-47887
The number of pages: 10
Approximate weight : 30 g (0.07 lbs)
Country: American technical standard
Category: Technical standards ASTM
Keywords:
acoustic emission, AE, dead-time, gain, preamplifier, sensitivity, sensor, signal processor, threshold, ICS Number Code 17.140.20 (Noise emitted by machines and equipment)
1. Scope | ||||||
1.1 This practice is recommended for use in testing and measuring operating characteristics of acoustic emission electronic components or units. (See Appendix X1 for a description of components and units.) It is not intended that this practice be used for routine checks of acoustic emission instrumentation, but rather for periodic evaluation or in the event of a malfunction. The sensor is not addressed in this document other than suggesting methods for standardizing system gains (equalizing them channel to channel) when sensors are present. 1.2 Where the manufacturer provides testing and measuring details in an operating and maintenance manual, the manufacturer's methods should be used in conjunction with the methods described in this practice. 1.3 Difficult or questionable instrumentation measurements should be referred to electronics engineering personnel. 1.4 The methods set forth in this practice are not intended to be either exclusive or exhaustive. 1.5 The methods (techniques) used for testing and measuring the components or units of acoustic emission instrumentation, and the results of such testing and measuring should be documented. Documentation should consist of photographs, charts or graphs, calculations, and tabulations where applicable. 1.6 AE systems that use computers to control the collection, storage, display, and data analysis are in common use. Features of the computer-based systems might include waveform collection as well as a wide selection of measurement parameters relating to the AE signal. The manufacturer provides a specification for each system that specifies the operating range and conditions for the system. All calibration and acceptance testing of computer-based AE systems must use the manufacturer's specification as a guide. This practice does not cover testing of the computer or computer peripherals. 1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||
2. Referenced Documents | ||||||
|
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
Latest update: 2024-05-19 (Number of items: 2 902 277)
© Copyright 2024 NORMSERVIS s.r.o.