Standard Practice for Reporting Data in Auger Electron Spectroscopy and X-ray Photoelectron Spectroscopy
STANDARD published on 1.11.2010
Designation standards: ASTM E996-10
Publication date standards: 1.11.2010
The number of pages: 3
Approximate weight : 9 g (0.02 lbs)
Country: American technical standard
Category: Technical standards ASTM
Auger electron spectroscopy, surface analysis , X-ray photoelectron spectroscopy, Auger electron spectroscopy (AES), Data analysis--spectrochemical, Recording/reporting data analysis results, Spectral data--metals/alloys, Surface analysis--spectrochemical analysis, ICS Number Code 19.100 (Non-destructive testing)
|Significance and Use|
Include the experimental conditions under which spectra are taken in the “Experiment” section of all reports and publications.
Identify any parameters that are changed between different spectra in the “Experiment” section of publications and reports, and include the specific parameters applicable to each spectrum in the figure caption.
1.1 Auger and X-ray photoelectron spectra are obtained using a variety of excitation methods, analyzers, signal processing, and digitizing techniques.
1.2 This practice lists the desirable information that shall be reported to fully describe the experimental conditions, specimen conditions, data recording procedures, and data transformation processes.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
|2. Referenced Documents|
Latest update: 2019-05-18 (Number of items: 2 245 518)
© Copyright 2019 NORMSERVIS s.r.o.