Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM F1458-98
Standard Test Method for Measurement of Cut Resistance to Chain Saw of Foot Protective Devices
STANDARD published on 10.10.1998
The information about the standard:
Designation standards: ASTM F1458-98
Note: WITHDRAWN
Publication date standards: 10.10.1998
SKU: NS-50372
The number of pages: 9
Approximate weight : 27 g (0.06 lbs)
Country: American technical standard
Category: Technical standards ASTM
Annotation of standard text ASTM F1458-98 :
Keywords:
Abrasion resistance-copy materials/printed products, Copy materials/products-office, Reflectometer, Smudge, Sutherland ink rub tester, abrasion/smudge resistance-images produced on office products, by, Sutherland test,, Chain saw, Cut resistance, Foot protective devices, Gaiters, Liners, Performance-protective clothing/materials applications, cut resistance of foot protective devices-chain saw, test, ICS Number Code 13.340.10 (Protective clothing)
Additional information
| 1. Scope | ||||
|
1.1 This test method measures cut resistance of foot protective devices which are designed to protect the foot when operating a chain saw. 1.2 This test method may be used to test for compliance to minimum performance requirements in established safety standards. 1.2.1 By agreement between the purchaser and the supplier, or as required by established safety standards, this test method can be used to determine any one or all of the following: (1) threshold stopping speed (2) pass/fail at specified chain speed, or (3) cut through time. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 1.4 The values stated in SI units or in other units shall be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system must be used independently of the other, without combining values in any way. |
||||
| 2. Referenced Documents | ||||
|
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
