Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM F327-08(2022)
Standard Practice for Sampling Gas Blow Down Systems and Components for Particulate Contamination by Automatic Particle Monitor Method
Translate name
STANDARD published on 1.4.2022
The information about the standard:
Designation standards: ASTM F327-08(2022)
Publication date standards: 1.4.2022
SKU: NS-1057089
The number of pages: 2
Approximate weight : 6 g (0.01 lbs)
Country: American technical standard
Category: Technical standards ASTM
The category - similar standards:
Annotation of standard text ASTM F327-08(2022) :
This practice describes the apparatuses needed, and the procedures for connecting, preparing, and sampling pressurized gas blow down systems and components for particulate contamination by the use an automatic particle monitor. The sensing unit of the automatic particle monitor is connected to the designated sample port which is under purge condition. The system flow rate is then adjusted to the sample flow rate requirement. Finally, all the gas passing through the sensing unit is monitored for particulate contamination until the required sample volume has been analyzed.
Keywords:
ICS Number Code 71.040.40 (Chemical analysis)
Additional information
| 1. Scope |
|
1.1?This practice describes how to connect, prepare, and sample pressurized gas systems (having up to 19.1-mm (0.75-in.) diameter lines) for particulate contamination by using an automatic monitor. 1.2?The values stated in MKS units are to be regarded as the standard. The values given in parentheses are for information only. 1.3?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
We recommend:
Updating of laws
Do you want to be sure about the validity of used regulations?
We offer you a solution so that you could use valid and updated legislative regulations.
Would you like to get more information? Look at this page.
