ASTM D3350-14
ASTM D3517-14
ASTM D3567-97(2011)..
ASTM D3681-12e1
ASTM D3754-14
ASTM D3839-14
Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM F610/F610M-15
Standard Practice for Evaluating the Quality of Molded Poly(Vinyl Chloride) (PVC) Plastic Pipe Fittings by the Heat Reversion Technique
STANDARD published on 1.3.2015
The information about the standard:
Designation standards: ASTM F610/F610M-15
Note: WITHDRAWN
Publication date standards: 1.3.2015
SKU: NS-583779
The number of pages: 5
Approximate weight : 15 g (0.03 lbs)
Country: American technical standard
Category: Technical standards ASTM
The category - similar standards:
Annotation of standard text ASTM F610/F610M-15 :
Keywords:
evaluating, fittings, plastic, PVC, quality ,, ICS Number Code 23.040.20 (Plastic pipes),23.040.45 (Plastic fittings)
Additional information
| Significance and Use |
|
3.1 This practice is applicable to distinguish between properly and improperly molded PVC plastic pipe fittings. It can be used to: 3.1.1 Determine whether cold slugs or unfused areas are present (Note 2), 3.1.2 Determine the amount of molded-in stress produced by the molding process (Note 3), 3.1.3 Reveal contamination, and 3.1.4 Show the quality of the weld line. Note 2: A cold slug is a piece of material that enters the
mold at a significantly lower temperature than the rest of the
mass.
Note 3: A stress-free part will generally have better
properties and higher strength than those with a high degree of
stress. Stress-free parts will generally react better when exposed
to chemicals.
|
| 1. Scope |
|
1.1 This practice covers a procedure for evaluating the quality of molded poly(vinyl chloride) (PVC) plastic pipe fittings after exposure to heat. 1.2 Units—The values stated in either inch-pound or SI units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. Note 1: The values in square brackets are SI units
requirements.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
Similar standards:
Historical
1.11.2014
Historical
1.3.2014
Historical
1.12.2011
Historical
1.4.2012
Historical
1.3.2014
Historical
1.3.2014
We recommend:
Updating of laws
Do you want to be sure about the validity of used regulations?
We offer you a solution so that you could use valid and updated legislative regulations.
Would you like to get more information? Look at this page.
