Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM F725-03
Standard Practice for Drafting Impact Test Requirements In Thermoplastic Pipe And Fittings Standards
STANDARD published on 10.4.2003
The information about the standard:
Designation standards: ASTM F725-03
Note: WITHDRAWN
Publication date standards: 10.4.2003
SKU: NS-56263
The number of pages: 4
Approximate weight : 12 g (0.03 lbs)
Country: American technical standard
Category: Technical standards ASTM
Annotation of standard text ASTM F725-03 :
Keywords:
impact testing, thermoplastic pipe and fittings, ICS Number Code 23.040.20 (Plastic pipes), 23.040.45 (Plastic fittings)
Additional information
| 1. Scope | ||
|
1.1 This practice describes a procedure for setting up impact test requirements on the basis of test data obtained by Test Method D 2444. 1.2 This practice is applicable to thermoplastic pipe and fittings. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||
| 2. Referenced Documents | ||
|
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
