Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
IEC 60301-ed.3.0
Preferred diameters of wire terminations of capacitors and resistors
STANDARD published on 13.7.2012
The information about the standard:
Designation standards: IEC 60301-ed.3.0
Publication date standards: 13.7.2012
SKU: NS-409408
The number of pages: 12
Approximate weight : 36 g (0.08 lbs)
Country: International technical standard
Category: Technical standards IEC
The category - similar standards:
Annotation of standard text IEC 60301-ed.3.0 :
IEC 60301:2012 gives a series of preferred diameters of the finished wire terminations of capacitors and resistors for use in electronic equipment. This third edition cancels and replaces the second edition, published in 1971, and its Amendment 1, published in 1972, and constitutes a technical revision. The main technical changes with respect to the second edition are the following: - employment of SI units only in the normative part of this standard, causing transfer of all imperial dimensions from Table 1 to the informative Annex A, - addition of two smaller diameters of wire terminations in Table 1, and - tightening of the tolerance ranges defined by minimum and maximum diameters in Table 1. La CEI 60301:2012 donne une serie de valeurs preferentielles pour les diametres des fils de sorties finis des condensateurs et resistances destines a etre utilises dans les equipements electroniques. Cette troisieme edition annule et remplace la deuxieme edition parue en 1971, ainsi que son Amendement 1, paru en 1972, et constitue une revision technique. Les modifications techniques principales par rapport a la deuxieme edition sont les suivantes: - utilisation dunites SI uniquement dans la partie normative de la presente norme, entrainant un deplacement de toutes les dimensions imperiales du Tableau 1 a lAnnexe A, informative, - ajout de deux diametres plus petits de fils de sorties dans le Tableau 1, et - abaissement des plages de tolerances definies par les diametres minimal et maximal du Tableau 1.
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
