Standards BS - British national standards - Page 7024

Specification for lead-acid and nickel-cadmium rechargeable batteries.

WITHDRAWN published on 29.7.1983

Schedule for environmental conditions and test procedures for airborne equipment.

WITHDRAWN published on 15.8.1993

Procedure for inspection and testing of wrought heat-resisting alloys.

WITHDRAWN published on 31.10.1978

Specification for nickel-chromium-titanium-aluminium heat-resisting alloy bar and wire for the manufacture of fasteners (maximum diameter or minor sectional dimension 30 mm) (nickel base Cr 19.5, Ti 2.2, Al 1.4).

WITHDRAWN published on 30.11.1989

Specification for pressure-sensitive adhesive waterproof PVC tape.

WITHDRAWN published on 31.10.1975

Specification for pressure-sensitive adhesive paper masking tape.

WITHDRAWN published on 31.10.1975

Specification for bars and extruded sections of aluminium-copper-magnesium-silicon-manganese alloy (solution treated and precipitation treated) (not exceeding 200 mm diameter or minor sectional dimension) (Cu 4.4, Mg 0.5, Si 0.7, Mn 0.8).

WITHDRAWN published on 31.8.1971

Procedure for inspection and testing of wrought aluminium and aluminium alloys.

WITHDRAWN published on 1.9.1981

Procedure for inspection and testing of aluminium-base and magnesium-base ingots and castings.

WITHDRAWN published on 30.9.1981

Specification for ingots and castings of magnesium - 10% aluminium-zinc-manganese alloy (solution treated) (Al 10, Zn 0.5, Mn 0.3).

WITHDRAWN published on 26.3.1970