Standards ČSN - Czech national standards - Page 5501

Zkoušení plastů. Příprava zkušebních těles z amorfních termoplastů s definovaným dodatečným smrštěním.

WITHDRAWN published on 28.12.1974

Plastics - Injection moulding of test specimens of thermoplastic materials - Part 1: General principles, and moulding of multipurpose and bar test specimens

Standard published on 1.2.2018

Plastics - Injection moulding of test specimens of thermoplastic materials - Part 2: Small tensile bars

Standard published on 1.7.2019

Plastics - Injection moulding of test specimens of thermoplastic materials - Part 3: Small plates

Standard published on 1.1.2021

Plastics - Injection moulding of test specimens of thermoplastic materials - Part 4: Determination of moulding shrinkage

Standard published on 1.7.2019

Plastics - Injection moulding of test specimens of thermoplastic materials - Part 5: Preparation of standard specimens for investigating anisotropy

Standard published on 1.7.2026

WITHDRAWN published on 17.12.1987

Plastics - Injection moulding of test specimens of thermoplastic materials - Part 1: General principles and moulding of multipurpose and bar test specimens

WITHDRAWN published on 1.8.1999

Plastics - Injection moulding of test specimens of thermoplastic materials - Part 2: Small tensile bars

WITHDRAWN published on 1.8.1999

Plastics - Injection moulding of test specimens of thermoplastic materials - Part 3: Small plates

WITHDRAWN published on 1.3.2004