Standards ČSN - Czech national standards - Page 5502

Plastics - Injection moulding of test specimens of thermoplastic materials - Part 3: Small plates

WITHDRAWN published on 1.8.1999

Plastics - Injection moulding of test specimens of thermoplastic materials - Part 4: Determination of moulding shrinkage

WITHDRAWN published on 1.8.1999

Plastics - Injection moulding of test specimens of thermoplastic materials - Part 4: Determination of moulding shrinkage

WITHDRAWN published on 1.9.2003

Plastics - Injection moulding of test specimens of thermoplastic materials - Part 5: Preparation of standard specimens for investigating anisotropy

WITHDRAWN published on 1.6.2018

Plastics - Injection moulding of test specimens of thermoplastic materials - Part 5: Preparation of standard specimens for investigating anisotropy

WITHDRAWN published on 1.8.2013

Plastics - Multipurpose test specimens

WITHDRAWN published on 1.6.1998

Plastics - Polybutene-1 (PB-1) moulding and extrusion materials - Part 2: Preparation of test specimens and determination of properties

WITHDRAWN published on 1.5.2010

Plastics - Polybutene (PB) moulding and extrusion materials - Part 2: Preparation of test specimens and determination of properties

WITHDRAWN published on 1.7.1997

Plastics - Vinyl chloride homopolymer and copolymer resins - Sieve analysis in water

Standard published on 1.9.2002

Plasty - Homopolymery a kopolymery vinylchloridu - Sítová analýza mokrým způsobem.

WITHDRAWN published on 1.10.1998