Nanomanufacturing - Key control characteristics - Part 6-5: Graphene-based materials - Contact and sheet resistance: transmission line measurement

Standard published on 14.12.2022

Nanomanufacturing - Key control characteristics - Part 6-6: Graphene - Strain uniformity: Raman spectroscopy

Standard published on 14.10.2021

Nanomanufacturing - Key control characteristics - Part 6-7: Graphene - Sheet resistance: van der Pauw method

Standard published on 7.6.2023

Nanomanufacturing - Key control characteristics - Part 6-8: Graphene - Sheet resistance: In-line four-point probe

Standard published on 7.6.2023

Nanomanufacturing - Key control characteristics - Part 6-9: Graphene-based material - Sheet resistance: Eddy current method

Standard published on 8.2.2022

Nanomanufacturing - Key control characteristics - Part 7-2: Nano-enabled photovoltaics - Device evaluation method for indoor light

Standard published on 27.7.2023

Nanomanufacturing - Key control characteristics - Part 8-1: Nano-enabled metal-oxide interfacial devices - Test method for defect states by thermally stimulated current

Standard published on 9.4.2020

Nanomanufacturing - Key control characteristics - Part 8-2: Nano-enabled metal-oxide interfacial devices - Test method for the polarization properties by thermally stimulated depolarization current

Standard published on 5.1.2021

Nanomanufacturing - Key control characteristics - Part 8-3: Nano-enabled metal-oxide interfacial devices - Analogue resistance change and resistance fluctuation: Electrical resistance measurement

Standard published on 20.10.2023

Nanomanufacturing – Key control characteristics – Part 8-4: Metal-oxide interfacial devices – Activation energy of electronic trap states: Low-frequency-noise spectroscopy

Standard published on 16.12.2024