Standards ISO - International Organization for Standardization - Page 344

Road vehicles — Endurance braking systems of motor vehicles and towed vehicles — Test procedures
(Véhicules routiers — Véhicules a moteur et véhicules tractés disposant de systemes de freinage d´endurance — Procédures d´essai)

Standard published on 28.8.2006

Thermoplastics materials for pipes and fittings for pressure applications — Classification, designation and design coefficient
(Matieres thermoplastiques pour tubes et raccords pour applications avec pression — Classification, désignation et coefficient de calcul)

Standard published on 27.10.2009

Hollow taper interface with flange contact surface — Part 1: Shanks of types A, AB, C, CB and EB
(Interfaces a cône creux-face — Partie 1: Queues de type A, AB, C, CB et EB)

Standard published on 20.10.2023

Hollow taper interface with flange contact surface — Part 2: Receivers of types A, C and E for hollow taper shanks of types A, AB, C, CB and EB
(Interfaces a cône creux-face — Partie 2: Nez de broches de type A, C et E pour queues a cône creux-face de type A, AB, C, CB et EB)

Standard published on 20.10.2023

Hollow taper interface with flange contact surface — Part 3: Shanks of types T, TA and U
(Interfaces a cône creux-face — Partie 3: Queues de type T, TA et U)

Standard published on 20.10.2023

Hollow taper interface with flange contact surface — Part 4: Receivers of types T and U for hollow taper shanks of types T, TA and U
(Interfaces a cône creux-face — Partie 4: Nez de broches de types T et U pour queues de types T, TA et U)

Standard published on 20.10.2023

Hollow taper interface with flange contact surface — Part 5: Shanks of types AS, CS and ES
(Interfaces a cône creux-face — Partie 5: Queues de type AS, CS et ES)

Standard published on 20.10.2023

Hollow taper interface with flange contact surface — Part 6: Receivers of types AS, CS and ES for hollow taper shanks of types AS, CS and ES
(Interfaces a cône creux-face — Partie 6: Nez de broches de types AS, CS et ES pour queues de types AS, CS et ES)

Standard published on 20.10.2023

Tools for moulding — Components of compression and injection moulds and diecasting dies — List of equivalent terms and symbols
(Outillage de moulage — Composants des moulages par compression, moules d´injection et moules pour fonderie sous pression — Termes et symboles)

Standard published on 6.11.2019

Plain bearings — Hydrostatic plain journal bearings with drainage grooves under steady-state conditions — Part 1: Calculation of oil-lubricated plain journal bearings with drainage grooves
(Paliers lisses — Paliers lisses radiaux hydrostatiques avec rainures d´écoulement fonctionnant en régime stationnaire — Partie 1: Calcul pour la lubrification des paliers lisses radiaux avec rainures d´écoulement)

Standard published on 14.6.2023