Standards ISO - International Organization for Standardization - Page 345

Diesel fuel — Assessment of lubricity using the high-frequency reciprocating rig (HFRR) — Part 2: Limit
(Carburant diesel — Évaluation du pouvoir lubrifiant au banc alternatif a haute fréquence (HFRR) — Partie 2: Limite)

Standard published on 13.7.2017

Boiled reproduction cork — Grading, classification and packing
(Liege de reproduction bouilli — Calibrage, classification et emballage)

Standard published on 8.12.2017

Road vehicles — Endurance braking systems of motor vehicles and towed vehicles — Test procedures
(Véhicules routiers — Véhicules a moteur et véhicules tractés disposant de systemes de freinage d´endurance — Procédures d´essai)

Standard published on 28.8.2006

Thermoplastics materials for pipes and fittings for pressure applications — Classification, designation and design coefficient
(Matieres thermoplastiques pour tubes et raccords pour applications avec pression — Classification, désignation et coefficient de calcul)

Standard published on 27.10.2009

Hollow taper interface with flange contact surface — Part 1: Shanks of types A, AB, C, CB and EB
(Interfaces a cône creux-face — Partie 1: Queues de type A, AB, C, CB et EB)

Standard published on 20.10.2023

Hollow taper interface with flange contact surface — Part 2: Receivers of types A, C and E for hollow taper shanks of types A, AB, C, CB and EB
(Interfaces a cône creux-face — Partie 2: Nez de broches de type A, C et E pour queues a cône creux-face de type A, AB, C, CB et EB)

Standard published on 20.10.2023

Hollow taper interface with flange contact surface — Part 3: Shanks of types T, TA and U
(Interfaces a cône creux-face — Partie 3: Queues de type T, TA et U)

Standard published on 20.10.2023

Hollow taper interface with flange contact surface — Part 4: Receivers of types T and U for hollow taper shanks of types T, TA and U
(Interfaces a cône creux-face — Partie 4: Nez de broches de types T et U pour queues de types T, TA et U)

Standard published on 20.10.2023

Hollow taper interface with flange contact surface — Part 5: Shanks of types AS, CS and ES
(Interfaces a cône creux-face — Partie 5: Queues de type AS, CS et ES)

Standard published on 20.10.2023

Hollow taper interface with flange contact surface — Part 6: Receivers of types AS, CS and ES for hollow taper shanks of types AS, CS and ES
(Interfaces a cône creux-face — Partie 6: Nez de broches de types AS, CS et ES pour queues de types AS, CS et ES)

Standard published on 20.10.2023