ČSN EN 1991-1-2..
Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM E564-06(2012)
Standard Practice for Static Load Test for Shear Resistance of Framed Walls for Buildings
STANDARD published on 1.10.2012
The information about the standard:
Designation standards: ASTM E564-06(2012)
Note: WITHDRAWN
Publication date standards: 1.10.2012
SKU: NS-47226
The number of pages: 5
Approximate weight : 15 g (0.03 lbs)
Country: American technical standard
Category: Technical standards ASTM
The category - similar standards:
Annotation of standard text ASTM E564-06(2012) :
Keywords:
framed walls, racking loads, rigid support, shear displacement, shear stiffness, shear strength, ICS Number Code 91.010.30 (Technical aspects)
Additional information
| 1. Scope | ||||||
|
1.1 This practice describes methods for evaluating the shear capacity of a typical section of a framed wall, supported on a rigid foundation and having load applied in the plane of the wall along the edge opposite the rigid support and in a direction parallel to it. The objective is to provide a determination of the shear stiffness and strength of any structural light-frame wall configuration to be used as a shear-wall on a rigid support. 1.2 Limitations—This practice is not intended to be used as a basis for classifying sheathing shear capacity or as an evaluation of combined flexure and shear resulting from the wall being loaded on a flexible foundation. 1.2.1 The effect of sheathing variations is assessed by holding all other variables constant. Permitted variations in framing configuration and boundary conditions, however, require accurate documentation of the test setup to validate across-study comparisons of sheathing contribution to wall shear capacity. 1.3 The values stated in SI units
are to be regarded as standard. The values given in parentheses are
mathematical conversions to inch-pound units that are provided for
information only and are not considered standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||
| 2. Referenced Documents | ||||||
|
Similar standards:
1.8.2004
WITHDRAWN
1.6.2013
1.6.2005
WITHDRAWN
1.4.2013
1.4.2007
1.5.2005
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
